Gunco Forums banner

Ak, barrel to press in & out, jig or tool source?

1K views 5 replies 5 participants last post by  AKaTom 
#1 ·
Is any one selling a tool or jig to use with a 12 ton press to remove the AK rear trunion pins, install and remove the barrel relatively safely? Someone mentioned somewhere that XEBEC sold such a tool? if not him anyone else? Thanks
 
#3 ·
If you have a press and a vise all you need is a pulley puller from autozone #25190. The press is all you need to put the barrel back in. When you say pins on the rear trunion, you mean rivits? Drill throught he center of them and punch them out.
 

Attachments

#6 ·
I've got the Xebec press kit and can't imagine building without it!

That said, mbadboyz i've never seen a barrel pressed in like that before but it looks pretty straightforward. I may give that a try, as much as I like my press kit, using it to push the barrel back in is a pain "for me".
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top