Gunco Forums banner

mg 34 dimensions wanted

5K views 11 replies 4 participants last post by  vz58 
#1 ·
What is the diameter, thickness and length of the barrel shroud?
What is the diameter of the barrel?
Can someone post a pic of the exterior shape of the receiver. (I found a few but not real clear)
What are the diameters of the cooling holes in the barrel shroud?

Thanks
 
#2 ·
Vz,

The barrel shroud:

OA length: 22 15/16"
Front of rec. to rear ofbooster/bipod mount block: 20 1/2"
Front of rec. to start of perforations: 7"
Perforated tube section: 13 1/2"
Booster/bipod mount block: 2 3/8"
Cooling hole diameter: .550"
Large rear portion of shroud tube OD: 1.650"
Main shroud tube section OD: 1.489"
Approx. wall thickness rear: .187"
" " " mid section: .088"
" " " front section: .065"

The Barrel:

OA length including the extension: 24 9/16"
Dia. at the muzzle, straight turned approx. 4": .851-.852
Steps up here to: .868"
Tapers back to the straight turned area of 2 1/2" 1.099-1.100"

If you don't find any suitable pictures, post back here and I will take some of my TNW and e-mail them to you. Can't get it done today, but can do it on the weekend.

HTH
Emory Jones
 
#8 ·
vz58 said:
Wow that is nice. I am thinking of a dummy gun reasonably close to the orig. Those will help!
Are you bidding on the Gunbroker Receiver pieces?
I don't bid against Gunco members if I can help it.
 
#10 ·
Ok now I need the heigth distance from bore center line to feed tray where the round sits ready for stripping. And the distance from breach face to bullet tip as it sits in the tray ready for stripping. Anyone? And receiver width flat vertical side to flat vertical side.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top