Gunco Forums banner

Need a slab side AR15 lower receiver

1K views 8 replies 6 participants last post by  vbrtrmn 
#1 ·
I am working on a new type of rifle. I need a slabside type receiver. The more material on the sides of the magwell the better. Can anyone here make one?
The closest thing I've seen to what I need is this. JP Rifles#

If anyone can help me. E-mail me at gwailo7@gmail.com

Thank you
gwailo
 
#4 ·
what machining capabilities do you have? How complete do you want it?
vz58
I have very little machining capabilities. I am a Millwright, not a machinist. I do have friends though. I would like it as complete as possible, or anything I could get. The most important thing is, the O.D. width of the magwell from the front of the receiver to the front of the trigger guard. I would like it to be 1.50 inches if possible? Like this.


Colt Model 602, 604, 605, 607, 608, 609, 610.
Pics link. Contact Us


Thank you
gwailo
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top