Gunco Forums banner

First AR build pics

1K views 9 replies 6 participants last post by  j427x 
#1 · (Edited)
Hi Guys,

Well I finally got most of my "Honey-do" list done, so now it's time to start on my AR project. Here's a link to what I did so far on the lower. Let me know what you think. Only mistake so far was counterboring the rear takedown pin a bit too deep, but I'll make a shim to cure that....
 
#8 · (Edited)
Hi Guys,

Got some spare time, so I headed to the shop and finished the machine work on the Lower and everything fits like it should. What I thought I screwed up on (rear takedown pin) ended up perfect. I did make an error in calculating the layout holes for the magazine (partially the fault of the instructions, but ultimately my fault for not paying attention - duhhhh), but I fixed it and all is well. You can view the pics here....

Now to start on an upper.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top