gave you a pop over at WG on this Sprat & told people to come look. :-)
Sprat, thanks for the info, I had never heard of those before. But it seems to be a good idea for a polymer receiver, I suppose it would help to prevent undue pressure on the holes and prevent them from egging out
Nemo ME Impune Lacessit
Manus sapiens potens est
пиштоли не убиваат луѓе, тие само го прават тоа полесно
there area couple different types of these pins...
all the way from $27 to 100....
thanks for the plug over at WG do I win some sort of contest??????
I know you guys are keen on those
Sprat and sprat1 are one and the same.
you only get my thanx for sharing info & knowledge.. that & $1 will get you a small cup of coffee..... but its better than a stick in the eye.
Enforcement, NOT Amnesty!!!!!!
"If they’re going to come here illegally, apply for & receive assistance through a corrupted Government agency encouraging this lawless behavior, work under the table & send billions of dollars each year back to their families in Mexico, while bleeding local economies dry, protest in our streets waving their Mexican flags DEMANDING rights, while I have to press ’1′ for English, then they need to be shipped back to where they came from!" -Chad Miller
Has anyone fired a gun made from the blems yet? My rear pin holes are about .040 too high. I'm wondering what kind of issues could come from that.
I've called these guys a few times and they just aren't answering the phone (shrug).
I'm not sure the rear pin hole is located wrong, but it was reported in a thread at Calguns that the takedown pin head recess is a bit off center. Their are a few good pics - See #2:
I think mine is too, but it should be an easy fix vwith a dremel or end mill. For the price its do-able.