Gunco Forums banner

Very new to Saiga 7.62x39

1K views 4 replies 3 participants last post by  Coils 
#1 ·
Does any one know of a good place to read up on the basic things to do before firing a new Saiga? The so called service manual that came with the gun is a piece of crap. My Saiga was made in 2009. I had a previous post about a scope mount rail. Some responders are saying it should have one and it might but I am very new to this type of rifle and am not sure what the rail looks like. The crap manual should be giving me this information, I would think.

So, again, Is there a better place to read up on what I should be doing before I test fire my new Saiga?

Bigdog
 
#2 ·
Bigdog, your Saiga should be ready to go to the range stright out of the box. A few things to do fist.
1 Remove the top Cover by pushing on the rear spring, and lifting off the top cover.
2 Remove the bolt carrier and bolt, by pulling to the rear. Pay attention to what you are doing.
3 Clean barrel and chamber, to remove any grease or dirt.
4 Remove gas tub, and clean.
5 Put back together, and have fun at the range or pits.

Hope this helps.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top