Gunco Forums banner

Saiga 12 Conv.

6K views 17 replies 11 participants last post by  bsouthnow 
#1 ·
19" barrel. Hogue rubberized pistol grip.
MD Arms 20 rd. drum, Ace folding stock.
G2 trigger (double hook), using the original hammer.
Made my own trigger guard out of heavy gauge stainless.
Test drive tomorrow.



 
See less See more
2
#3 ·
The stock hammer was already fitted for width to fit beside the
bolt hold open plate, which hinges on the hammer's axis pin.
It was just an expedient thing to do.
 
#8 · (Edited)
Late development.
Had another day off, and was looking at Quad-rails for my Saiga.
$200 is not my idea of being able to use a vertical fore-grip.

After many brain farts. I went to my local auto parts store and
bought an 18" section of 1-3/4" exhaust pipe.

I studied the plastic stock forward lower, and put the pipe in my
large vise and mashed it to match contours of stock item.
Installed a picatinny rail on the bottom, plug welded it in.
Mimicked the Cetme hole pattern on the lower.
Welded on a G3 front and rear sight.
Hot damn! I feel more satisfied now.

[The Hogue Grip is a winner, a slight cushion effect, very ergonomic]






 
#9 ·
Thanks for the info on the grip.

And DAMN you did get a lot done!!! Looks even better

Favor asking time. :D
Can you try to get a pic of the sight picture, close to how it would look when you look through those sights?
 
#14 ·
Here she is with the Tapco trigger and Saiga hammer.
I may need to put on some weight.
10 round dumpl

[video=youtube;pxHWEajeokU]http://www.youtube.com/watch?v=pxHWEajeokU]YouTube - Saiga 12 rapid fire[/video]
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top