Gunco Forums banner

U bend em flats

627 views 2 replies 3 participants last post by  sniper69 
#1 ·
Who else here has one of E&D's version 1 laser cut flats?

The ones without the LH selector hole and the front cut incorrectly.

The problem with the front is that it was cut squared to the bottom instead of the top.
After welding I squared the front with the top, tapering the cut from the bottom to the top, removing 0 material at the top.
The problem is that now the receiver is almost .125 too short in the OAL.

I contacted E&D, (who had admitted to the problem on the other board) about a replacement, I never even received a reply.

How many others here, are stuck with one of these paper weights?
 
#2 · (Edited by Moderator)
7.62x39......

Maybe you had the wrong email (majorwest at charter.net). I think that's the correct email. I remember them saying something about those who had the earlier flats could get them replaced.

When I purchased mine they were the new and improved flat. Hope you get some sort of response from them.
 
#3 ·
i have two of the early u bend em's and if I could get the one I haven't messed with replaced that would be great. Is that the correct email address? (guess it is time to find the paypal receipt, lol).
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top