Results 1 to 2 of 2

Thread: Barrel pin length

  1. #1
    Gunco Member Gadwall13's Avatar
    Join Date
    Jul 2009
    Location
    PA
    Posts
    96
    Feedback Score
    0

    Default Barrel pin length

    All this talk about barrel pins has got me wadering about correct length. My Yugo pin is .125" short of reaching the outside edges of the trunnion (.0625 on each side). It is the same pin that came out of the kit.
    The pin on my Bulgy kit that I had to drill out is slightly longer than the trunnion width. This seems more correct.
    I also noticed that the pins that CNC Warrior sell are slightly long compared to my trunnion measurements. About a tenth inch longer.
    Should I look into replacing the pin on my Yugo?

  2. #2
    No Hope For Me 1biggun's Avatar
    Join Date
    Oct 2005
    Posts
    13,661
    Feedback Score
    14 (100%)

    Default

    any thing sticking out is just extra. a yugo trunion (m70) is really wide compared to other trunions if the pin is slightly less than flush it wont hurt. a flush or slightly past flush would look better however.

Search tags for this page

There are currently no search engine referrals.
Click on a term to search our site for related topics.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •