I'm getting close to finishing the new receiver. Used measurement and not a Template this time. So far so good.
The one I demilled is put one side until I can find someone to Weld up those rear holes for me.
Pulled out the original receiver stubs for that kit. Sure enough, the factory had to cut the rear of the original Romanian receiver(1986)to accommodate fitting rear trunion and dust cover.
I'm just guessing, you know throw anything out to make you think it over.
If you go this route again, make sure everything is lined up and just center punch the holes, then drill. This way you don't have to worry about keeping everything lined up while drill.
Here's 2 themplates if you want to compare them to each other
Edit; use the links below
Last edited by Coils; 12-08-2013 at 05:31 AM.
"Government is not the solution to our problem, government is the problem" Ronald Reagan
Both of these pages are missing with the templates on them.