Well, this started I thing in August last year. I ordered a GT custom receiver. Between F' Ups and hurricanes, etc...I finally got the receiver last week. I'm, not 100% happy with the finish, but it will do for now. I need to place an E clip inside the receiver to retain the selector lever and spot drill the selector markings. I ran a mag through it, it runs perfect. I'll probably retake these pics tomorrow....
Last edited by BigAl; 03-10-2006 at 10:09 AM.
"It's all over but the cryin'!"Moonshiner
I think shes purdy, I never meet a Tantal I didnt like. I wouldnt wanna be on the dumb end of it.
American By Birth, Southern By the Grace Of God
Tell me could you put a scope rail on it by locating it just a little forward on the receiver?
I know you've been working on it all day...but take a pic during the daylight...It looks like you have a titty-pink upper handguard.
The selector looks like it turned out right on the money.
How did you end up getting the selector dimple out?
We supported the inside of the reciever with 1.25" of steel blocks and then pressed from the outside. It still had a little print of the die Global uses to stamp with, but you can't see it with the Tantal selector installed.Originally Posted by bsn
Now I'm glad I ordered one! Hope mine looks that good when done!
That's a beauty!!
There is no nonsense so errant that it cannot be made the creed of the vast majority by adequate governmental action. -- Bertrand Russell
"Never attribute to malice that which can be adequately explained by stupidity." Robert J. Hanlon
Fine job Al