Gunco Forums banner

#1 done, its a F-AK...14 more to go!!!!!!

720 views 9 replies 8 participants last post by  truckjohn 
#1 ·
#4 ·
Think of it as a practice in multicultural diversity!! Carry that AK as a proud badge of correctness!!

Did you drill the gas hole after setting the block or before?

And it looks real good.
 
#8 ·
d.hauser said:
i increased the gas port to 1/8, i drilled it after it was installed. started straight up and down then once i had it deep enough to bite, i tilted the barrel down then drilled it the rest of the way.
That sometimes was the toughest part for me as I couldn't figure a set up and did it free hand. I have broken a bit inside the gas block that was partially in the barrel effectively pinning the two.

:angry: :angry: :angry: :angry: :angry: :angry: :angry: :angry:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top