good shit SS,
good shit SS,
[Drawings for the spade grip option for the MG47ES are available free for those who purchased a set of MG47ES drawings. Send me an PM or e-mail and I will e-mail you a PDF file containing 5 sheets of drawing for the spade grips. You can change from the grip stick and butt stock to the spade grips and back in less than a minute.
Last edited by SHARPSSHOOTER5090; 06-21-2008 at 09:00 AM.
received the CD today. the drawings are fantastic will sent email for spade grip option
Any US Vet or service man in uniform that wants a set of MG47ES drawings, E-mail me and I will e-mail back a set no charge.
Last edited by SHARPSSHOOTER5090; 06-24-2008 at 06:21 PM.
Just got my plans today and all I can say is WOW!!. I printed two pages off and took them out to dinner with me. Guys get a set of them they are very well done. Thanks Tom
Dave B In OR
While working on the tutorial for the MG47ES I discovered 2 dimensions that should be revised on sheet 4, Bolt Carrier Extension.
1; On the lower left end view the .21" dimension from the bottom to the center of the .25 diameter bolt holes should be .175".
2; The over all dimension of the bolt carrier extension should b 3.875" long and not 4" long.
Please make these changes to your drawings. Any one that wants a revised copy of sheet 4, e-mail me and I will e-mail you back a revised sheet 4. Sorry for the inconvenience, it can be made to work with the dimensions on the drawing but will work better with the revised dimension.
Don't give up hope for the MG47ES tutorial. I am editing it now.
I tried to pm and email for instructions but I am new to this board and cannot do either. Can you email me please? thank you
Well done, I recently received the prints. I used to be a tool maker and can really appreciate a good set of drawings.
Where are these belts ? Who sells them?