View Full Version : question about g2 fcgs
03-18-2006, 08:53 PM
i have a double hook and dci recevers are single. just to make sure i need to cut a second hole for the other hook correct?
03-18-2006, 09:04 PM
yes you do, just match it up to the other side. it needs room to pivot. good luck with it. Twissted
You can also relieve the bottom of the trigger where the right side would contact a single hook receiver.
03-18-2006, 09:50 PM
Yes, just file a matching notch on the trigger opening of the receiver. Five minutes with a round file and you will be done.
03-19-2006, 07:17 PM
ok. i drilled a hole with a #23 bit and used a saw to cut to the hole. it turned out well and works fine now to put this damn tapco retainign spring in and im set.