Gunco Forums banner

hotbarrel's receiver wrench

17K views 134 replies 33 participants last post by  FloridaAKM 
#1 · (Edited by Moderator)
This thread is a continuation of this thread.

http://www.gunco.net/forums/showthread.php?t=32883

Who's interested?
7.62x39


is this the tool made from 2 pieces of flat stock milled out to the profile
I think a neibor of mine has one I can easy copy . do you have any pic just to be shure..
 
#133 ·
brutis
I am sorry but I do not have enough material to make another set.
I recomend you post a thread and ask if anyone could loan you a set... for now at least.
hope this helps.
 
#135 ·
I went and bought a receiver wrench from a shop that was selling out all of their old unused, unsold stuff for $50.00 along with the tool needed to remove the buttstock. Reading about Hottbarrels work on the wrenches was an intresting read as it was informative!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top