That's the same kit I got - lots of good stuff in it ;) The cutting tools will wear out the first time you use them but everything else is good to have. I mounted as much as I could on the wall near the mill so as to keep everything organized.
Looks like the same basic vise I have too. Don't rely on the markers around the vise, mine was off by about 1/2 degree. You might be able to reset the pointer, but I usually mount it then tram it across the X- axis to ensure it is zeroed. I find I usually have to remove the vise "pads" that clamp the pieces to give myself more room when clamping. You'll know what I mean if you have to do it :)
Found that link to vz58's washer pan bath: