Since you can build things, you should look at the flat bending jig plans in the library area the 555th designed, but then you won't have any of the impressions for the X/Y for FCG or safety pivot area unless you add them.
If that works for you then you could have a local company cut out blanks with a water jet or laser cnc.
Here you go on the flats, without & with trunnion holes
Originally Posted by Plan B
I received the GG mag today. Thank you very much!
I wedged it into a dimpled receiver I have for mockup. Other than the dimples, it looks like it will fit just fine.
Is this going to be a blowback or gas operated?
I can not find that bloody blank with no dimples, now you found the solution I will find the blank next week I m still looking???
good luck with the project interesting
Yes, please keep looking.
I don't want to use a dimpled receiver for this.
I was wrong. I just received the Stemple 76/45 magwells today and the O.D. is right at 1.25 (dimples are a no go)
seems like if you ground the dimples off and used those holes to weld in the magwell you would be GTG
still can't find the blanks they are here, somewhere heck i am offering them to you
if you go without me finding them, Im good, but one week later i will find them!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! murphys law
I'm in no big hurry for it. It's 2nd on my build list since I'm waiting on bolt parts.
I'm just trying to get as much done on it as I can. (I like these Stemple 76/45 magwells)