07-16-2008, 11:03 PM
Where do you get these belts from?
07-16-2008, 11:19 PM
If you are looking for the MG3 belts, robertrtg.com and Inter Ordnance both have them.
07-17-2008, 03:52 AM
They sure know what they want for those covers and feed trays.
07-20-2008, 12:33 AM
I was browsing Aim Surplus and they have Austrian MG3 belts and a ammo can for 20 frog skins so I ordered some. Next Ill get the cover and feed thingy. I can hardly wait to get thing going. I think I might put a pintel mount on my fishin boat and intimidate some game warden ass.
07-28-2008, 04:31 AM
The tutorial for the MG47ES is ready. A 87 page picture tutorial for building the MG47ES on CD. This is a companion to the drawings and describes how to build the MG47ES with out a mill, lathe or welder. PM or E-mail SHARPSSHOOTER5090 info.
08-27-2008, 08:37 AM
The MG47ES tutorial and drawings is free to U.S. service personnel and veterans. PM or E-mail SHARPSSHOOTER5090 for info.
08-31-2008, 10:53 AM
Can't do much more than read and look at the prints till I get back in the states but this is one serviceman who appreciates your generosity.
Thank you (again).
09-04-2008, 10:27 PM
Do you use the regular FCG pins in the FCG tray? Also, what pin do you use for the trigger pin in the gripstick?
09-05-2008, 01:12 AM
I have used the regular FCG pins in the FCG tray but with the heads cut off. Same with the gripstick pin except the head is not cut off. I have also used a 3/16" diameter round drill rod when I didn't have the regular pins. The inside wall of the receiver keeps them in place except the gripstick pin needs a retainer inside the gripstick housing. I have used a small hairpin clip for that.
09-05-2008, 09:14 AM
I am in the middle of building parts and I am sure I'll have a few more questions.