Need measurement for PPS-43 Trunnion
I think I read here that someone has this dimension. Would you help a fellow out?
Originally Posted by jungp
1.890 overall length
Bottom Hole .375
Top Hole .250
Relief on bottom .125
Bottom lip where barrel sits
.250 thick (above the 1.25 relief)
Does that help, that's one trunnion, I am sure that others might be different.
Thank you. Will try that out.
Does that include the dimension for the bottom cut where the flat piece sits?
Here's the prints I downloaded a while back:
Thank you very much. Exactly what I was looking for.
Originally Posted by kernelkrink