"Man needs but two things to survive alone in the woods. A blow up female doll and his trusty old AK-47" - Thomas Jefferson 1781
I found that you can use a thin ss ruler to hold the spring & detent in place while you insert the take down pin in place. Nothing is perfect as somewhere in my livingroom there is an errant detent when I tried my first one!
"If God had not intended for us to eat animals, how come He made them out of meat?" - Sarah Palin
New Member of the Busted Box Club
I used a punch (I forget what size) that was close to the size of the receiver holes to capture the detent while I slid the pin from the other side. I figured that out after launching my first one across the kitchen.
Been quite a while since I've been on this board, but wanted to update you on my absence.
First, I did finish my AR15 build and am very happy with my work on the lower. I wish I could say the same for the upper (JSE Surplus). I took the rifle out to the range, and all seemed well for the first couple shots, then the rifle started to short stroke on me. I looked the gun over and all was in order, so I figured it was the ammo (Federal 55gr), so the fellow next to me gave me some Remington factory (55gr also) and the rifle reacted the same (jamming and cases ejecting forward). Well I took it home and tore it down and was totally shocked by what I found. First, the gas hole was half covered by the gas block (the people that build for JSE, drilled the gas hole without taking into consideration the thickness of the handguard retainer - beginner's mistake). Second, the gas hole wasn't drilled all the way through (the .078 gas hole was only about half its size, which meant they didn't break through the barrel, hence, about a .045" hole at best). Needless to say, I drilled the gas hole through, replaced the gas block with a low profile one, drilled detents for the gas block retaining screws to lock into, and installed a customizable handguard from Yankee Hill. All is well now and will range test again next week - Hopefully my problems are solved - we'll see.
Second, I built an AR10 from a raw forging, and also did the barrel from a blank from Green Mountain, I wrote a tutorial on the AR10, much along the lines of Ray-Vin's Tutorial and you can view it here. You can see my completed project here. I had to make all the tooling for the AR10 also and you can see some of it here.
Third, I am working on a Zombie shotgun with my brother. We're using an old JC Higgins model 20, 12ga (which, by the way is one of the finest pump shotguns ever built - Hi Standard 200). We are installing a pistol grip and forend assembly from ATI, whose intended use is the Mossberg 500, but with a few minor mods can be made to fit the old JC. The barrel heat shield needs to be cut and fitted to rings that are silver soldered to the barrel, then for some sandblasting and GunKote. No pics yet, but hopefully soon.
Hope to post back soon....
NRA Life Member - 1976
Wow! That is a beautiful build! Nice tools you have made also. Thanks for the update and welcome back!!
Gunco member #11
“it is dangerous to be right in matters about which the established authorities are wrong” Voltaire