hmmmm I used a polish rail set on my weiger clone an a tapco universial on the others.
is the 223 an 5.56 rear ward in the reciver vs a 7.62????
I had honestly really never tought about it being in a different location until this thread.
id like to know how far the tip is from the end of the reciver or breach face on a 223
the weiger clone really dents the case in the middle while my romy varmint set up dings the shoulder .
ill have to compare the two. an see were there positioned . either way tere likely going to hit . the romy bolt has a extracter much like a 5.45 were the bolt is cut away around it. so the different style of extracter might be the big difference.
I would like to know this as well. I built an adjustable gas block to keep the cases from getting dented. If moving the ejector back would help that would be good. Mine is made on romy 7.62 kit, bulgy bbl & bolt,weiger & bulgy mags. Had to narrow bottom of romy carrier to go thru feed lips. Its a great shooter. Wish this ammo shortage would slack up. I'd really like to take her out to the range again.
"NA BEAN DON CHAT GUN LAMHAINN"