Results 1 to 5 of 5

Thread: building my own rivet jig

  1. #1
    Gunco Rookie XxxSOxxX's Avatar
    Join Date
    Mar 2014
    Location
    CA
    Posts
    3
    Feedback Score
    0

    Question building my own rivet jig

    Hello all,
    I'm kinda new to this whole AK building and I want to build my own rivet jig.I will be using the plinker style jig as my guide.
    I'm wondering how to get the long rivets to form. I have been told just a 1/4 ball end mill but do I need to step up to 1/4 or will it form with just the 1/4 ball, and depth of the ball in my shoulder bolts to starting the forming?Is there a certain depth I should start at so I don't just fold the rivet over? any help would be greatly appreciated

    Thanks Shawn
    Last edited by XxxSOxxX; 03-16-2014 at 06:36 PM.

  2. #2
    No Hope For Me Coils's Avatar
    Join Date
    Feb 2005
    Location
    PA Where the Amish Roam Free
    Posts
    13,646
    Feedback Score
    38 (100%)

    Default

    Measure a rivet head from the top of the dome to the base, or start the hole with the ball mill and keep checking the fit of a rivet head in it.

    Most people say to have 1 1/2 times the shank diameter sticking out, I've only used AK Builder rivets and they worked fine without trimming.

    Hope that helps


    And welcome to the forum
    "Government is not the solution to our problem, government is the problem" Ronald Reagan

  3. #3
    Gunco Member usmc3531's Avatar
    Join Date
    Feb 2012
    Posts
    129
    Feedback Score
    1 (100%)

    Default

    I use both sides of the bolt the one side has a hole just slightly wider than the rivet to start it, then the other side rounds it over, just make sure the hole is not so deep that it bottoms out on the reciever
    Attached Images Attached Images

  4. #4
    Gunco Rookie XxxSOxxX's Avatar
    Join Date
    Mar 2014
    Location
    CA
    Posts
    3
    Feedback Score
    0

    Default

    thanks for the reply's , I made a few out of 5/16 shoulder bolts today couldn't find a 1/4 in our ball end mill drawer had a 5/16 I think it was, fit the ak builder rivet head ok. hoping I can finish it up by the end of the week. just need to heat treat and start squishing

  5. #5
    Gunco Rookie XxxSOxxX's Avatar
    Join Date
    Mar 2014
    Location
    CA
    Posts
    3
    Feedback Score
    0

    Default

    just about finished
    I found a 1/4 end mill that had the tips ground, matches up to the center support rivet going to see what I can get out of it (far right shoulder bolt).
    Attached Images Attached Images

Search tags for this page

There are currently no search engine referrals.
Click on a term to search our site for related topics.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •