Gunco Forums banner

milled parts on stamped receiver

738 views 4 replies 3 participants last post by  mboehlke 
#1 ·
This has probably been asked a 1000 times but I can't find a reference yet. question is can a parts kit for a milled receiver be used in a stamped one? I know there are some barrel issues but will the trunnions be ok?
 
#2 ·
Yes you can.
But more details on the kit will help. Does it have a barrel, or any pieces of the milled receiver?

If you don't have any of the receiver pieces you can get a trunnion and stock tang, the barrel may need to be fitted to the trunnion. If there's no barrel and only the parts that go on the barrel, you'll need an AK47 profile barrel, an AKM barrel is smaller in diameter.
Check out this thread, it's the newest one on the subject, not much info but it's a start.
http://www.gunco.net/forums/f3/ak-build-help-71017/
 
#4 ·
Yes you can.
But more details on the kit will help. Does it have a barrel, or any pieces of the milled receiver?

If you don't have any of the receiver pieces you can get a trunnion and stock tang, the barrel may need to be fitted to the trunnion. If there's no barrel and only the parts that go on the barrel, you'll need an AK47 profile barrel, an AKM barrel is smaller in diameter.
Check out this thread, it's the newest one on the subject, not much info but it's a start.
http://www.gunco.net/forums/f3/ak-build-help-71017/
Thanks for the info, was looking at a Bulgy milled kit. I've got several flats that need parts and was interested in the mating process. Again Thanks
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top