That looks cool to me!
Last edited by gwailo; 11-17-2013 at 03:34 PM.
That looks cool to me!
Enforcement, NOT Amnesty!!!!!!
"If they’re going to come here illegally, apply for & receive assistance through a corrupted Government agency encouraging this lawless behavior, work under the table & send billions of dollars each year back to their families in Mexico, while bleeding local economies dry, protest in our streets waving their Mexican flags DEMANDING rights, while I have to press ’1′ for English, then they need to be shipped back to where they came from!" -Chad Miller
Last edited by gwailo; 11-14-2013 at 09:00 AM.
Scored the .22 AK dust cover I need on Ebay of all places.
Last edited by gwailo; 11-16-2013 at 05:55 PM.
I like the idea but if you use a forward grip it becomes an AOW.
I should have said a modified MP5K/SW89 type handguard, but I didn't know if everyone would know what that is?
Last edited by gwailo; 11-16-2013 at 10:36 AM.
there is thread running on the weapons forum were there is discussion of a shortblow back pisotol . Im considering a custom bolt like the EOD but it will run on square stock rails or some thing an the bolt will install from the back via a removable rear trunion . I was thinking if dome right no guide rod would be needed .
htat second pick doan is a locking lug gun BTW . I pposted that same pin the other day on a differant site .
I picked up some polish unfinished front trunions the other day to use for these .
I think I can shorten the recvier on a blow back in 9mm by about 4" in hte front with some careful planing .
Last edited by gwailo; 11-17-2013 at 03:56 PM.
I know, I shortened the receiver on my 9mm AK.
The first prototype, I started out with a Draco and modified EOD 7.62X25 bolt. I reverse engineered my Vityaz clone from the it.
The EOD design couldn't be modified for my new shorter receiver and the manufacturer refused to do any design changes, so I was forced to design my own bolt. I timed my bolt to control out of battery fire and it has a spring loaded firing pin.
The EOD firing pin is free floating and stuck forward one time, causing a full auto mag dump. It was just too dangerous. I ended up spring loading it also.
This is my AK guru buddy bumpfiring the first prototype with a modified EOD 7.62X25 bolt.
Last edited by gwailo; 11-16-2013 at 12:55 AM.