Do you have the rivets for the center supposrts?
these u drive screws eliminate the need for removing the barrel . Just drill 1/4 deep hole for the front tronion and set in place with hammer. the drill rear trunion 3/8 deep and set screw with hammer .Keep the rivet look without the having to push out the barrel trouble. All prices are shipped$7.00 thiere are no trigger guard screws in this set . this set perserves the rivet look
$9.00 screws or rivets for trigger guard$11.25 underfolder set
$12.00 there is no need for riveter with this set
anybody need rivets
gas piston replacement rivets $0.75 with order
New Items
Tapco FCG Single or Double Hook
$29 Shipped to your door
US Made Pistol Grips Non Tapco but same quality
$10 Shipped
e-clips are $0.15 with order or $1.95 for 10 shipped
center support are $2.00 with order or shipped $2.50
drills bit are$2.00 or $1.50 with order
all sets come with drill bits
You need to have your item descriptions read in very vague non-gun terms.
If using paypal paypal ID [email protected]
here is a how to thread for using the udrive
http://www.gunco.net/forums/showthread.php?t=25450
Last edited by killerone; 08-04-2008 at 05:42 PM.
Do you have the rivets for the center supposrts?
yes they work with the udrive sorry about the confusionOriginally Posted by bloodsport2885
center support
Heck i will take a set of what ever i need for my next Romy. Where to send funds?
Consider this, Amateurs built the Ark, Professionals built the Titanic
Ocala and Marion County Car Audio
paypal ID [email protected]Originally Posted by ptannjr
or postal M.O.
Miguel Aquino
35891 SW 187 Ave
Florida City, FL 33034
udrives are great, iv used them and they seem a winner for me
Are the E-clips SAE or metric. Thanks
sae all of my AK's have them I have yugo under folder with about 400 rounds threw it and it works just fine
If I may suggest, if those are 1/4 drive screws and you drill 1/4 down there is no room left to get a good smash on the drive screwI would go a little shallow.
"It's all over but the cryin'!"Moonshiner
drill as as the length of the udrive thats what I did and they are solid. I try to pry apart , slam , pull ,basically everything to try to get it off with my hands ,becuase it would be better it came apart in my hands at home , than at the range with live rounds