Gunco Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #3 ·

·
Premium Member
Joined
·
6,900 Posts
The IBE blank is fine, I built my first AK using one of Bob's blanks, before the Ace blanks became available.

The Ace blanks are closer to the finished size, requiring a little less trimming, but either one will work fine.

As far as heat treating goes, The only holes to be concerned with are the axis pin holes.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top