Gunco Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
hey guys. where can I find a good description of how to put the fcg together? the hollow split pin with a flare on one end, which direction does the flare go,left or right? thanks
 

·
Registered
Joined
·
2,071 Posts
I'm not sure about which side the hollow pin goes, I just stuck it in. I'm really not sure if it matters. Check this out for installation.
 

·
Master Endmill Breaker
Joined
·
1,367 Posts
I always put the flare to the big side of the pin (ejector side). I don't think it really matters.
 

·
Registered
Joined
·
2,071 Posts
I looked at my Century SAR1 and it has the little flange on the left side (side that has rail with ejector).
 

·
Registered
Joined
·
40 Posts
Discussion Starter · #5 ·
thanks guys!
 

·
Premium Member
Joined
·
6,900 Posts
prophet said:
hey guys. where can I find a good description of how to put the fcg together? the hollow split pin with a flare on one end, which direction does the flare go,left or right? thanks
How are you making up for the FCG in your parts count?
Remember, the anticipated AWB sunset will not effect the fact that you can have no more than 10 imported countable parts in your rifle.
 
1 - 6 of 6 Posts
Top