Gunco Forums banner

amd65 part question

591 Views 6 Replies 6 Participants Last post by  yosuthnmasa
Ok, I got this junk with my AMD65 kit. to the left is the center support right?...but whats the deal with that thing that screws on the end of it? why is the edge beveled? i also have a spring, sleeve, and tiny little spacer. Would I save more hair if I just ordered a center support instead?


See less See more
1 - 1 of 7 Posts
A 5/16 split pin 1.25" long can be ground to fit and uses the standard long rivet.

1/4" rod can be cut and the ends turned down if the lower rails are to be welded.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.