Gunco Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter · #1 ·
I have a Saiga that I want to convert to a highcap; the trunnion already has the hole for the rivet drilled. I have removed the rivet that blocks the installation of the bullet guide. Any ideas on how to set the rivet with the trunnion already in the receiver ? TIA for any ideas or suggestions.
 

·
Registered
Joined
·
48 Posts
bulletslap said:
I have a Saiga that I want to convert to a highcap; the trunnion already has the hole for the rivet drilled. I have removed the rivet that blocks the installation of the bullet guide. Any ideas on how to set the rivet with the trunnion already in the receiver ? TIA for any ideas or suggestions.
Tap the floor of the trunnion and use a screw. Remember, red loctite is your friend.

Disconnector
 

·
Registered
Joined
·
39 Posts
Discussion Starter · #3 ·
I thought about screwing it, threading the trunnion hole that is, but I would really like it to look like it was riverted in place. Maybe I'll just silver solder it and the rivet in place.
 
1 - 3 of 3 Posts
Top