Gunco Forums banner
1 - 5 of 5 Posts

·
Gunco Samurai
Joined
·
3,340 Posts
Discussion Starter · #1 ·
Can you think of a way to attach this FAL/M249 style carry handle to a picatinny rail?

I like it to come off the side of Ultimak's new lower handguard thats coming out.

Its for a special project. :)
 

·
Happy Camper
Joined
·
7,794 Posts
Yeah.

Rail-mounted block, like a flashlight mount or vertical foregrip mount, to which is attached a clamp that screws down for the bushing end of the handle. WOuld need to be milled but you could dremel it too, if you are only making one.
 

·
Premium Member
Joined
·
6,900 Posts

·
Registered
Joined
·
4,077 Posts
JB weld and duct tapt what else... HAHAHA no honestly I think the guys above have some good ideas. I just had to have some fun.
 

·
Registered
Joined
·
1,386 Posts
You could take a Hi Weaver ring, grind it down to where the bottom of the ring is gone, then use a bolt and bushing to secure handle to mount. I could try to draw a pic, but I don't draw any better than I type. You would have to drill a hole in the remaining part of the ring. Any how I wish I could explain it better.
 
1 - 5 of 5 Posts
Top