Gunco Forums banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
6,900 Posts
Discussion Starter · #1 ·
I finally got a chance to spend a little more time on this.
I got the front cartridge stop, rear cartridge stop and pintle pad riveted on.
The side plate is now ready to be riveted back on.

I was a little concerned about deforming the front cartridge stop when riveting it in, so a made a little jig.
The stop is 5/8" long, so I scrounged up a piece of 5/8" bar stock and drilled a "N" hole through it. This made the face of the stop perfectly level with the top of the bar. Voil?, instant jig.
It worked perfectly, keeping the stop at exactly 90 degrees to the plate while pressing.
 

Attachments

1 - 1 of 1 Posts
Status
Not open for further replies.
Top