[erikk]

Does anyone know where to get chinese pins? I understand they are a bit longet than the regular ones and since I am building with a reciever made from 064 thickness sheet metal the regular ones are too short. Anyone else had this problem & how did you overcome it? Please don't say I made my own!!

Thanks for any help

 

[mike26038]

www.polytechparts.com

1-800-848-4671

Call and ask for Chloe, she is great and will help you out..

They have then listed at $4.95 each PART# 70-00-25A


Mike

 

[Winn R]

It's a bit of a pain but another way to do it is to take a washer, I've forgotten the size, and tack it on the inside of the right hand hole. I had to redrill the hole every time because of the weld.

I also stuck them in place with JB weld. I have to go down and find the one I did that way but if I remember right, it's had at least a couple hundred rounds through it and if it's broke loose I don't know about it.

A third way, on the eighth inch thick weld packs, was needed because the shepherds hook groove wasn't exposed. Those were countersunk so that the surface of the heads are flush with the outside of the sidewalls.

 

[erikk]

Thanks for all the tips guys !! I just knew there had to be a solution