Gunco Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
i got a franken ak parts set the other day, and has what i assume is a chinese underfolder. after using the old rear stub to mark my holes with, i found that in the closed position, it swings way past were the forearm, and even the barrel will be. did these stocks not lock closed?? whats the deal?
 

·
Visiting MOD
Joined
·
2,141 Posts
They did "lock" closed, but on my pre-89 CHICOM folder it is not locked up solid.

It has about 1/4 of movement from the handguard to where the lock is.

I suspect that you are not getting a full lockup or your holes on the receiver are too big.
 

·
Registered
Joined
·
37 Posts
Discussion Starter #3
the holes are ok, i was going to weld up and redrill the holes when i decided to reassemble the folder on the old stub, and found the original rifle had to have done the same thing.i am not familier with any uf stock, so i thought maybe there was a latch that kept it folded. i will go ahead and weld it up, i should have checked it in the folded pos. before i drilled anything
 
1 - 3 of 3 Posts
Top