Gunco Forums banner
1 - 1 of 1 Posts

· Happy Camper
7,801 Posts
Discussion Starter · #1 ·
I have personally measured this against my Hesse/Vulcan receiver, and 2 other Norinco receivers, and the plans match up fine against all 3 of these receivers for both the mag well & FCG parts... trunions seem different so its best to measure these yourself, in case yours is off by a small amount.

To print, you need to set the printer settings for 1:1 ratio... this worked fine on my HP inkjet printer.

A few checks after you print out, is to verify the width is 1.25 inches, and the length is 10.25 inches. That will confirm you are working with a "good" print out.

Here is the DXF on my web server (doesn't want to upload):

You can download a trial version of Deltacad from here:

- Jerry
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.