Gunco Forums banner
1 - 1 of 1 Posts

· Registered
51 Posts
Discussion Starter · #1 ·
lower comes with the tower already threaded for the buttstock, and both sides of the lower are "dimpled" showing you where to drill the holes for the crosspins. No drill jig is needed,no tap, no lathe for threading the tower. It's well worth the extra $60 he charges, over the other junk 80% lowers that are available.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.