Gunco Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
85 Posts
Discussion Starter · #1 ·
Do the kits come with parts to keep the folding stock locked in place? I bought one from Centerfire and im not sure those parts are there.
 

·
Registered
Joined
·
2,214 Posts
The parts that make it lock are in the plastic bag. there is a spring , a shoulder screw and a locking wedge that the screw threads into.

good luck:)
 

·
Registered
Joined
·
85 Posts
Discussion Starter · #3 ·
Thanks for the info,this will be my first build.I think the parts are there.Now i take it that the side of the OOW 100% reciever has to be cut outfor folder to swing and a hole drilled in the bottom for the screw head? Am i correct? Other than that i think im good to go.
 

·
Registered
Joined
·
318 Posts
Just fit the trunion and then cut out the slot with your dremel. Cut it a bit proud and them use a stone to get the finished fit. Then get a drill bit the same sixe as the small hole in the trunion and run it through your receiver fot the pin. Mike the bottom of the locking screw (the end with the screw slot) and enlarge the hole to accept it so it moves freely. Assemble with spring and anvil looking part and you got it...
 

·
Registered
Joined
·
3,518 Posts
If you have any problems pooikies web site would help you.
 
1 - 7 of 7 Posts
Top