[hcpookie]

Test #1... ah ah ah

http://pookieweb.dyndns.org:61129/dimples.jpg

The way things look, I'm going to have this done just about the time I have to pack up and move! But its off to a good start. That's 22-gauge sheet metal, the cheap stuff from Lowe's.

Now to curl the sides and rear. Then to create a "flat" template, then cut some blanks, then....

 

[scubadvr]

Jerry, you amaze me!!! When is the big move? Jack

 

[mike26038]

Way to go Jerry, I wish I could do half what you have done.. :notworthy

 

[sniper69]

Test #1... ah ah ah

http://pookieweb.dyndns.org:61129/dimples.jpg

The way things look, I'm going to have this done just about the time I have to pack up and move! But its off to a good start. That's 22-gauge sheet metal, the cheap stuff from Lowe's.

Now to curl the sides and rear. Then to create a "flat" template, then cut some blanks, then....

Am I correct in assuming that you are making some US made waffle mag floorplates? Are they for the 7.62 or the 5.45 mags?

 

[hotbarrel]

that looks like a real nice start. keep it comming

 

[hcpookie]

Am I correct in assuming that you are making some US made waffle mag floorplates? Are they for the 7.62 or the 5.45 mags?

Yes, yes, and yes. Emphasis on US-made!

The 7.62 waffle floorplates and the 5.45 floorplates are one and the same.

 

[hcpookie]

Jerry, you amaze me!!! When is the big move? Jack

The big move is ASAP... no sooner than next weekend. I'm going house hunting w/ my friends some this weekend and next week.

If the relocation assistant would contact me, I could get pre-approved for a loan that much faster... I hate being held up by someone else's "plans". Hate it.

 

[scubadvr]

The big move is ASAP... no sooner than next weekend. I'm going house hunting w/ my friends some this weekend and next week.

If the relocation assistant would contact me, I could get pre-approved for a loan that much faster... I hate being held up by someone else's "plans". Hate it.

Yea but you are going to love the location!!! Good luck, Jack

 

[Winn R]

Jerry-- ain't them mills fun.

 

[hcpookie]

Indeed they are! Mills goood... moving bad