Gunco Forums banner
1 - 4 of 4 Posts

·
Chinese Connection
Joined
·
2,094 Posts
Discussion Starter · #1 ·
I am start my Romak 3 build today, and I notice the Mag release does not have catch and spring, I got all the parts I spend few hr try get it but without luck. any tips ????
 

·
Registered
Joined
·
825 Posts
I had to use a set of needle nose pliars to hold the catch and spring at the same time. I pushed everthing in place under spring tension and my wife pushed the pin it. It takes two sets of hands this way. Another way would be to use a small diameter pin punch and use it as a temporary pin. Install the real pin while pushing in the catch to line it up. The real pin will push out the temporary pin (punch. I hope this makes sense, because it took me a heck of a long time to figure it out and get mine in.
 

·
Chinese Connection
Joined
·
2,094 Posts
Discussion Starter · #3 ·
how about broke tapping screw ? how you fix that ?
 

·
Registered
Joined
·
4,077 Posts
It has been too long now for me. All I rember is it was a strong spring and it took a few atempts.
 
1 - 4 of 4 Posts
Top