Gunco Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
318 Posts
Discussion Starter · #1 ·
Anyone have a drawing for the hole location & measurments for the underfolder stock? Going to use a 80% bent blank.
Thanks
 

·
Registered
Joined
·
1,523 Posts
PM me your email and I can send the full size one.. I can't get tit resized small enough so pm me and I'll email it to you...
 

·
Registered
Joined
·
260 Posts
underfolder template

mike26038 said:
PM me your email and I can send the full size one.. I can't get tit resized small enough so pm me and I'll email it to you...
Hi. I just joined today so you probably won't want to deal with me but I will ask anyway. I have built 2 amd 65's so far and made the receivers from scratch using 3/16 hot rolled steel and 1/8th for the top rails. I am now working on a polish underfolder and a drawing of the rear trunion location would be very helpful to me. My email address is [email protected] Thanks Don Also I can't seem to figure out how to attach a picture to the threads. To disarm the people {is} the best and most effectual way to enslave them...} George Mason
 

·
Registered
Joined
·
5 Posts
drawings of ak underfolder location

:ar15:
mike26038 said:
PM me your email and I can send the full size one.. I can't get tit resized small enough so pm me and I'll email it to you...
Could you please send me the drawing for the hole location and size on the underfolder ak? email [email protected]
 
1 - 7 of 7 Posts
Top