Gunco Forums banner
1 - 2 of 2 Posts

· Registered
93 Posts
Discussion Starter · #1 ·
I've seen a lot of posts about pressing a barrel out of a trunnion. Seems like you need a hydraulic press and I can understand how this set up works. How does one press a barrel in? I'm assuming the barrel trunnion is now riveted into the receiver. How do you get the barrel into the receiver? Seems like there is a lack of surfaces to work against.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.