Gunco Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
825 Posts
Discussion Starter · #1 ·
Moving the table of my 20 ton press is such a pain when pressing barrels, riveting, bending flats and pinning, that I stuck an air operated lift cylinder on it. I guess I have to put some kind of regulator on it, because i just about launched the table!
 

·
Registered
Joined
·
4,077 Posts
flow controll valve on the return line.. basicaly a needle valve. regulator will drop pressure but not realy solw the flow. it will only slow the speed by weakening the piston's force, with a flow controll you will still have full power and be able to accuratly adjust the speed. also a smoother movement, I bet a flow controll will cost less too.. what a deal
 
1 - 2 of 2 Posts
Top