Gunco Forums banner
1 - 2 of 6 Posts

· Master Endmill Breaker
Joined
·
1,302 Posts
Discussion Starter · #1 ·
Glad to see this site up and running! Glad to see some familiar "faces" too.
 

· Master Endmill Breaker
Joined
·
1,302 Posts
Discussion Starter · #3 ·
Progress on rifles is halted until my MG Midget is back up and running. After that I'm going to finish the Romak and then the .45 conversion construction can finally start.
 
1 - 2 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top