Mag feed adjustment/selector stop plate

945 Views 6 Replies 6 Participants Last post by Trotsky, Oct 1, 2004

keiser

Discussion Starter · Sep 29, 2004

Just starting out and was wondering if someone could give me a tutorial on the proper procedure to adjust feed from the mag and modifying the thickness of the selector stop plate. Is everyone doing this? What if you need a thicker plate? Do most of you use a new selector stop plate under the trigger guard? Thanks for the info.

Save

1 - 1 of 7 Posts

7.62x39

· #3 · Sep 30, 2004

I've had to thin a couple out, but I have not run across a case where a new plate was not thick enough.
Only had one, where a new plate was required. The original was pretty worn.

Save

1 - 1 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.