Gunco Forums banner
1 - 17 of 17 Posts

·
Gunco Samurai
Joined
·
3,340 Posts
Sweet!!! is that the RPB extended MB that AKUSA makes?
 

·
Gunco Samurai
Joined
·
3,340 Posts
Did you cut down your SAR-1 Barrel or buy a 104 barrel assembly from KVAR?
 

·
Registered
Joined
·
1,386 Posts
Discussion Starter · #5 ·
Polish Taipan said:
Did you cut down your SAR-1 Barrel or buy a 104 barrel assembly from KVAR?
Cut crowned and threaded the existing barrel. The only thing is I had to weld it to the barrel to be legal. Cut the front sight and tig welded it to the gas block.
 

·
Gunco Samurai
Joined
·
3,340 Posts
Could you post a pic of the FSB/GB?
 

·
Gunco Samurai
Joined
·
3,340 Posts
Cool thanks. I only ask because I think it would be sweet to do with my SAR1. Get it even a little more custom.
 

·
Registered
Joined
·
4,077 Posts
what thread did you cut on the end of the barrel... 14x1,L ??
I tried to buy a 14x1,L TAP and they wanted $159 and a die was about the same. yikes way too much for me
 

·
Registered
Joined
·
1,386 Posts
Discussion Starter · #13 ·
Yep, 14x1mm lefthand.

hotbarrel,
Ya can borrow mine, but I don't have a guide ( which you have to have ) I borrow a 30 cal. spud from a friends bore sighter to use as a guide. You have to be careful as crooked threads ain't a good thing.

P.S. I only have a die, don't know what I would need with a tap??
 

·
Gunco Samurai
Joined
·
3,340 Posts
Looks great, thanks.
 

·
Gunco Irregular
Joined
·
4,323 Posts
That is nice!! I would like to do something similar but leave the barrel long and open up the muzzle brake so that it fits over the barrel. I'm not sure if the diameter of the muzzle brake would allow it though.
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top