Gunco Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Here is my AR15 pistol build. It is built on a Stagarms lower striped receiver that I had yellow formed as a pistol. I used a Model1 71/2 inch barrel and parts kits. A chrome bolt carrier assembly. i also use a DPMS 22 cal conversion for cheap shooting. Red dot site and mounts are from CDNN. the buffer tube I made from a C.A.R. buffer tube I cut off the positioning holes and added a cap at the end so no buttstock could be put on it so the AFT wouldn't say is was a SBR.

BOB G
 

Attachments

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·
The recoil is like 9mm. The flash is like a 3 foot ball of flame.
I have $90 in the stripped lower, $325 from model1 for upper parts and receiver parts kit, $110 for the bolt assembly the buffer tube I in my parts box. I think it was $50 or so for the mounts and site. That's not to bad for a AR pistol that is not made of plastic and didn't cost $1000.
 

Attachments

1 - 5 of 5 Posts
Top