Gunco Forums banner
1 - 3 of 3 Posts

·
Happy Camper
Joined
·
7,794 Posts
No, they bend up to 18 gauge is all. HF sells one that bends 16 gauge (thicker) for $20. I think they could work, but cheaper deals can be had...

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=39103

Others have reported that the 4130 sheets aren't flexible in comparison to mild sheet steel, and so you'll have to reinforce these w/ a backing plate or bar of some sort, and then they should be doable. Preheating the metal with a torch wouldn't hurt either.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top