Gunco Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,071 Posts
OK, so lets say one of us wanted to have one of the thicker receivers. What exactly do they mill on the trunnion. How much do they take off on both sides? If I've got access to a milling machine, exactly how hard would it be to do this? You have to mill not only the sides inside the receiver, but what about the lip with the groove that the edge of the receiver slides into. Does that have to be widened out, or can you just file down the lip of the receiver so that it fits in without having to widen the groove? How much do they charge to have this done? If this isn't hard maybe I could look into milling a few of these.
 
1 - 1 of 1 Posts
Top