[shadow29483]

THIS RIGHT NOW IS THE ONLY THING HOLDING UP MY POLISH BUILD.
COULD ANYONE GIVE ME A GOOD PIC. OR ANY TYPE OF MEASUREMENT OR DIAGRAM OF THE "TOP" BOLT/CARRIER RAILS. :dunno: :dunno: :dunno:
A PICTURE WOULD BE SUFFICE, BUT MEASUREMENTS WOULD BE OUTSTANDING! :headspin:
I KNOW IT'S .20" AND THE FRONT IS A SMALL LIP BUT I NEED THE CUT OUT NOTCHES FOR THE RECEIVERS "TOP" RAILS. IT'S BEEN AWHILE SINCE MY LAST BUILD AND I'VE MISPLACED THE MEASUREMENTS.
THANKS GUYS, :dunno: :dunno:
-SHADOW-

 

[Abwehr]

Top Rail

THIS RIGHT NOW IS THE ONLY THING HOLDING UP MY POLISH BUILD.
COULD ANYONE GIVE ME A GOOD PIC. OR ANY TYPE OF MEASUREMENT OR DIAGRAM OF THE "TOP" BOLT/CARRIER RAILS. :dunno: :dunno: :dunno:
A PICTURE WOULD BE SUFFICE, BUT MEASUREMENTS WOULD BE OUTSTANDING! :headspin:
I KNOW IT'S .20" AND THE FRONT IS A SMALL LIP BUT I NEED THE CUT OUT NOTCHES FOR THE RECEIVERS "TOP" RAILS. IT'S BEEN AWHILE SINCE MY LAST BUILD AND I'VE MISPLACED THE MEASUREMENTS.
THANKS GUYS, :dunno: :dunno:
-SHADOW-

Shadow,

Go to the ACE website, and go to their tutorial section of the receiver machining. Here is the address to that page if it will post. http://www.acearms.com/tutorials/blank_build3.shtml

Hope this will help you.

 

[erikk]

Just use your bolt carrier. Depending on what bend you are using if you open up the rear so the carrier drops in you can tell from there how much you need to remove-dremmel time!!

 

[yosuthnmasa]

Just use your bolt carrier. Depending on what bend you are using if you open up the rear so the carrier drops in you can tell from there how much you need to remove-dremmel time!!

Shadow, does this make sense?

 

[shadow29483]

Yea man it makes great sense.
Thanks guys....Shadow.

Shadow, does this make sense?