Gunco Forums banner

- PLEASE....NEED HELP ON "TOP" RAILS-

450 Views 4 Replies 4 Participants Last post by  shadow29483
THIS RIGHT NOW IS THE ONLY THING HOLDING UP MY POLISH BUILD.
COULD ANYONE GIVE ME A GOOD PIC. OR ANY TYPE OF MEASUREMENT OR DIAGRAM OF THE "TOP" BOLT/CARRIER RAILS. :dunno: :dunno: :dunno:
A PICTURE WOULD BE SUFFICE, BUT MEASUREMENTS WOULD BE OUTSTANDING! :headspin:
I KNOW IT'S .20" AND THE FRONT IS A SMALL LIP BUT I NEED THE CUT OUT NOTCHES FOR THE RECEIVERS "TOP" RAILS. IT'S BEEN AWHILE SINCE MY LAST BUILD AND I'VE MISPLACED THE MEASUREMENTS.
THANKS GUYS, :dunno: :confused: :dunno:
-SHADOW-
1 - 1 of 5 Posts
erikk said:
Just use your bolt carrier. Depending on what bend you are using if you open up the rear so the carrier drops in you can tell from there how much you need to remove-dremmel time!!

Shadow, does this make sense?
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top