Gunco Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hello,

I just finished the assembly on my Polish underfolder. I'm not sure how I'm supposed to finish off the underfolder assembly. I don't know how tight to tighten the threaded collar that holds the folding axle together.
Is there a certain tightness at which the collar should be tightened?

Also, the threaded collar has a series of holes around the outside. Am I supposed to run a pin (cotter pin?) through the holes to keep the collar from twisting off?

David
 
1 - 1 of 1 Posts
Top